|◄ ◄ ▲
info map

SMU4000 Easy Setup presets


The SMU4000 series provides eight 'Easy Setup' presets to allow instant use of the SMU for specific use cases:
  • Power Supply
  • Current Source
  • Electronic Load
  • Voltmeter
  • Ammeter
  • Ohmmeter
  • Insulation Resistance (IR) meter
  • Leakage Current (LC) meter
These primarily configure the mode of operation of the source/sink. In all cases the measured voltage, current and derived measurements are available.

These setups can be edited using the manual setup mode configuration so also act as starting points for more complex configurations.
EASY SETUP PRESETS
NameSettable ParametersDefault SettingsMode*
Power SupplyVoltage Output+1VSV
Current Limit0.1A
Current SourceCurrent Output+1mASC
Voltage Limit5V
LoadLoad Current+1mALC
Voltage Dropout0V
Voltmeter--MV
Ammeter--MC
OhmmeterTest Current+1mAMR
Voltage Limit5V
Insulation Resistance MeterTest Voltage+20VMC
Current Limit1mA
Leakage Current MeterTest Voltage+20VSV
Current Limit1mA
*Operation Modes: SV: Source Voltage, SC: Source Current, LC: Load Current, LR: Load Resistance, LP: Load Power, MV: Measure Voltage, MC: Measure Current, MR: Measure Resistance- Voltage Limited, MHR: Measure Resistance- Current Limited