info map full screen

I-prober 520 Positional Current Probe

Step through the pages using the controls above, or select using the adjacent select list

Observe and measure current in a PCB track

I-prober with scope
  • Make measurements via non-contact probing
  • Suitable for observation and measurement of current in component leads & ground planes as well as PCB tracks
  • Wide dynamic range of 10mA to 20A pk to pk
  • Wide bandwidth of DC to 5MHz
  • Low noise equivalent to <6mA rms at full bandwidth
  • Minimal disturbance to circuit conditions through very low insertion impedance and stray capacitance
  • Safety rated to 300V Cat II (600V Cat I)
  • Suitable for connection to any oscilloscope
  • High accuracy general purpose H-field probe
  • Convertible into "closed magnetic circuit" current probe

The Aim I-prober 520

The Aim I-prober 520 positional current probe is unlike any other current measurement device available.

Calibrated measurement of current normally requires the current to be passed through a closed magnetic loop. Typically this is done using some form of split clamp device. Whereas this is suitable for individual wires, it is of no use for measuring current in PCB tracks.

The I-prober 520 is a compact hand-held probe which is used with an oscilloscope. By placing the insulated tip of the probe onto a PCB track, the current flowing in the track can be observed and measured.

This tour will cover the following topics:

How does it work?

Learn about the technical problems of current measurement in PCB tracks. This is a challenge that probe designers have battled with over the years without success - until now. Aim-TTi have used patented technology to enable currents to be observed and measured by precise positional measurement of field.

About the I-prober system

Learn about the different parts of the system and how they work together

Current Measurement

Learn about measuring current in a PCB track or wire

Closed Loop Measurement

Learn about measuring current in a wire using the clip-on toroid assembly

Electromagnetic field Measurement

Learn about measuring electromagnetic field with the I-prober 520

I-prober 520 specifications

What's in the box?


See Also...

The i-Prober 520 Home Page

For prices, datasheets, manuals etc

Other Links

Introductory Video A rather old video introducing the I-prober 520 when it was first launched (YouTube).
Watch an EEVblog video on YouTube Dave Jones gives you his assessment of the I-prober in his inimitable style.